Showing 157–168 of 221 results

Settlement Plate | Model 4625

The Model 4625 Settlement Plate System is designed primarily as an inexpensive means for monitoring in areas where significant settlement or substantial material displacement is expected. Datasheet

Settlement Profiler (VW) | Model 4651

The Model 4651 Settlement Profiler consists of a pressure transducer inside a torpedo which is connected by a long liquid filled tube to a liquid reservoir. The torpedo is pulled through a pipe buried in a fill, surcharge, embankment, etc. The transducer gives a measure of the elevation profile of the pipe relative to the reservoir located on stable ground. The liquid tube is stored on a reel. Datasheet

Settlement System (VW) | Model 4660

The Model 4660 Vibrating Wire Settlement System uses a Pressure Transducer attached to a settlement plate located in the settling ground. Datasheet

Signal Cable

GEOKON cables are designed for a variety of geotechnical and hydrological applications. Datasheet

Slim Size Piezometer Encardio Rite

The EPP-40V is specifically designed for measuring pore water pressure in small diameter boreholes and standpipes. Datasheet

Spot Weldable · Miniature (VW) | Model 4100 · 4150 · 4151

The Model 4100/4150 Strain Gauge has a 51 mm gauge length (3000 µε range, 1 µε sensitivity) and is designed to measure strains in steel structures (4100) and on reinforcement bars (4150) where space may be limited. Datasheet

Standard Piezometer (VW)

The Model 4500 Standard Piezometer is designed to measure fluid pressures such as ground water elevations and pore pressures when buried directly in embankments, fills, etc. Datasheet

Standard Piezometers (VW)

The Model 4500 Standard Piezometer is designed to measure fluid pressures such as ground water elevations and pore pressures when buried directly in embankments, fills, etc. Datasheet Manual

Standard Type (VW) | Model 4800

The Model 4800 Earth Pressure Cells* are designed to measure total pressure in earth fills and embankments. Datasheet

Tấm đo áp lực bê tông phun NATM

Cảm biến ứng suất bê tông phun kiểu NATM Model 4850* được thiết kế để đo ứng suất tiếp tuyến (4850-1) và ứng suất hướng tâm (4850-2) trong lớp lót đường hầm bê tông phun. Datasheet

Tấm đo áp lực đất

Cảm biến đo áp suất đất Model 4800* được thiết kế để đo tổng áp suất trong quá trình lấp đất và đê. Datasheet